 鲜花( 6)  鸡蛋( 0)
|
本帖最后由 craigliu 于 2011-3-13 12:10 编辑 - ]& h8 l% ^ e
5 {6 R& D, U) T. U) A"打算把这个硬盘拆下来连到另一台电脑上,可是怎么才能连上呢?".
: X. E: l& G; _5 {, Z$ }+ B* f; H1) Open case, you usually need to open two sides. ) h+ r" J# u: l; ~$ f
2) unplug cables that attached to the HD. Usually there are two cables (one for power, one for data).
" y) w$ |& r& p6 g3) unscrew for HD.4 m. j1 n8 C0 o$ x& c/ \1 C- S B
4) take out HD. K7 o/ C2 C* z* n
5) Usually The HD is set as Master, and you need to reset jumper pin into Slave. There is a label on the HD that indicators how you set jumper pin.
. P$ K- E( \$ j7 z2 P* R6) open the case of another computer.
9 O+ y% M. r% w {7) Connect all cables. (two cables. Only correct cable can be plugged. So just try, if you can plug in, it is right cable.)1 R3 ^8 d3 i U; U
8) start computer.0 p# c# E5 N# w2 k) B
' R8 z. R) m$ R# I; _) c' Z! G" Y% ]
(I suppose you use the HD that was popular before, because you use XP.) |
|