 鲜花( 242)  鸡蛋( 8)
|
本帖最后由 白马啸西枫 于 2009-12-31 21:24 编辑
( R) Z5 m- ?: R% W1 _7 j& P1 z' ]# B; ]$ q1 y: P5 |
22# 小黄
% W& B1 Q) p6 L9 j1 b+ K9 @6 D6 M! J4 w+ Z$ x6 H+ S! p
小黄,你说得对,但不全面。
% y8 |4 a. R7 s# l/ B6 Voverdrive 档是汽车的最高档,也叫超速挡,超比档,正如shark 27所说: 此时的引擎曲轴转一圈时,齿轮箱的输出轴却可转超过一圈。对引擎而言,就是输出轴端的扭力变小了:! V6 c( R" }$ X' t& z8 r
以下摘自维基百科:
2 _, B5 N ~" i' y4 |' @& o6 c- @超比(省油)档开关(O/D):自动变速器的最高档通常是超比档,该档位齿轮比(减速比)低于一,也就是该档位将引擎扭力放大倍数变成低于一倍,有助于省油,但不利于加速。超比开关关闭后,D档行驶时,自动变速器将无法换入超比档。通常在上坡及路面状况不良时应考虑将此开关关闭。0 c2 l' b3 p& h( I
A unit with a planetary gearset which turns the driveshaft faster than the transmission output shaft.
, F: d% U! r- I1 L7 rAn additional gearbox which is mounted in the driveline. Normally the final drive ratio is 1:1; but the overdrive makes it less (e.g., 0.87:1). The overdrive can reduce gas consumption at sustained high-speed driving, engine noise, and engine wear. Also called "overdrive transmission." Also see aftermarket overdrive
: k, }' o+ y- W+ B' V! K5 p" dGearing in which less than one revolution of a transmission's input shaft causes one turn of the output shaft. The purpose of overdrive is to reduce engine rpm in high gear for better fuel economy. Example: A transmission with an overdrive top gear has a ratio of 0.70 to one. Turning the input shaft 0.7 revolutions causes 1.0 revolution of the output shaft.: x* `! \- C# l% A l8 c3 |) |3 U
因为输出轴端的扭距变小,所以变速箱的设计师有意将其设计成超车时踩油会降档,以提高变速箱输出端的扭距离和加速度,从而使汽车更快地加速。 |
|